🔌 50ft SoundBox Connected 4AWG Red/Black Amp Power/Ground Wire Set for Amplifier Review

Perhaps you should label this product better and let everyone know that it is aluminum and not copper, which is not correct and should be clearly stated in the title description as it is one of the most important product details .

Purchased this kit to add an extra fuse box to the accessory. The wires have good thick insulation. I wish I had gotten a screw on the crimps because it was a PIA to crimp the ends. Using the factory hole in the firewall, I carefully routed the wire from the battery to the fuse box.

Neat power cables for installing an amplifier. I wouldn't use this cable for installation in a high end show car but it works fine. If you hide all the wire, you'll be fine. The fuse holder is pretty cheap, the plastic is brittle so I didn't use it. So don't expect much. But it works in a pinch or within budget.

Firstly I have no regrets purchasing this cable and still think it is great value for money but the issue with the fuse holder. I used this wiring to run a DC charger and it draws about 50-60 amps which was too much for a fuse holder. It melted after about 5 minutes of use but luckily the fuse blew before any damage was done. I think the fuse adapters have too much tolerance resulting in a loose fit. Under high loads, this loose fit created excessive resistance, leading to heat build-up. I…

The cable is cheap, the fuse is rubbish. Buy cheap Chinese junk. Well you know exactly what you have. Wire insulation is ok, not the toughest. The inner lining is very thin. This makes it flexible, but you'll snip a few wires with a razor blade when stripping. I tried soldering the ends of the fuse to the wire because I'm a perfectionist. The tail end began to melt along with the solder. The end deformed so much that I couldn't dip most of the wire into the melted solder. The finish on the ends

Perhaps you should label this product better and let everyone know that this is aluminum not copper which is not what you want and clearly does so in the title description should stand as it is one of the most important product information.

I bought this kit to add extra fuse box for accessories. The wires have good thick insulation. I wish I had gotten a screw on the crimps because it was a PIA to crimp the ends. Using the factory hole in the firewall, I carefully routed the wire from the battery to the fuse box.

Firstly I have no regrets buying this cable and I still think it's good value for money but the problem is the fuse holder. I used this wiring to run a DC charger and it draws about 50-60 amps which was too much for a fuse holder. It melted after about 5 minutes of use but luckily the fuse blew before any damage was done. I think the fuse adapters have too much tolerance resulting in a loose fit. Under high loads, this loose fit created excessive resistance, leading to heat build-up. I replaced