🔌 SPARKING 2FT SAE to Ring Terminal Harness with Quick Connect/Disconnect - 10A Fuse, 2FT Length Review

I wanted to add this to my JEEP Wrangler so I can charge it without the popping noise that always comes up. I do a lot of short trips and sometimes my car sits for days with no traffic because of a roadblock. The alternator normally charges the battery but sometimes does not have enough run time to fully charge the battery, especially when left unused for a long period of time. I bought a charger and it reduced the starting problems. The only problem was that the battery latches were difficult…

This SAE Wiring Harness is of high quality and uses fairly thick wire. Stronger than the shorter straps that typically come with chargers. The battery is located in the trunk under the dashboard and is not easy to reach. I have a charger on a convertible that doesn't get much use in the winter so I need an easy way to plug it in. The charger I bought came with a short wiring harness as well as short leads from the charger itself. This prevented me from plugging in the charger and leaving it on…

SAE plug can be confusing at times, so be careful and consider the intended use when purchasing. In the first photo you can see that the PIN on the plug is reversed. The open contact must always be such that its contact with earth does not short-circuit the supply to earth. SAE plugs have two purposes: supply or voltage to the device or input voltage. 1) If you notice that the top connector in the photo has an exposed pin since it is used as a ground source. So if he comes into contact with…