🚀 Enhanced TS58 Sender by Standard Motor Products Review

Worked like a dream on my 94ft Ranger. This part fixed my dash temp sensor. The old sensor barely registered on the pressure gauge, the readings were very low. Replaced by this, the sensor now correctly reads the temperature of the engine. Good price and timely shipping.

Hi guys, this sensor solved my problem right away. Easy to install; The sensor has been pre-sealed to prevent leakage. If you are in doubt that the problem is in the sensor; Disconnect the wire from the old sensor and ground it. If the problem is in the sensor, the sensor is completely hot or completely cold. This will tell you that the old sensor is defective.

Requires swivels and socket extenders for installation. Be careful not to cross the threads. I smeared dielectric grease on the electrical contact with a wire on the header. I'm just saying. NAPA/Zone/Advance all wanted $25-$30.

Not much wrong but good quality. This is for your pace. Gauge Not to be confused with you The coolant temperature switch that provides the computer with information that affects how rich or lean your car is running. This should send a message to the electrical temperature sensor in the dash. It might work with some that only have light. Go to your application. I've seen some people doing it themselves, which they're trying to replace Mixed Up with. It will not improve your car's performance…

Ideal for replacing the factory coolant temperature sensor on a full size '94 Bronco. There are two sensors. This is ONLY used to display the engine temperature on the dashboard. He doesn't do anything else. There is another sensor that is used to measure the coolant/cylinder head temperature to send data to the onboard computer to complete the fuel injection circuit. That's a different sensor. A symptom of a malfunction of this sensor is a problem with the dashboard. There is no check engine…