🔌 STARELO Electrical Replacement Plug & Connector Set: Yellow Shell, 125V 15A 2Pole 3Wire NEMA 5-15P & 5-15R Industrial Grade 3-Prong Straight Blade Grounding Type – Buy Now! Review

Not the best. Look around for the best product. Looks cheap, the plastic is flimsy compared to others I've used. The two halves of each end don't actually interlock and aren't very strong when trying to assemble them with the wires installed. I decided to further weatherproof the joint with sealant as they are in no way weatherproof.

. But not at this point. This time you get what you pay for. When I first used this, the ground pin socket collapsed inwards. When disassembled and tested, the outlet guides simply float freely and are not tied to anything. Also, they are only lightly crimped with a plate connected to the wire. This is a low quality product that I would only trust to start a fire.

Made several attempts with the connector end to securely and securely attach 12 gauge extension cords. Unfortunately the size of the screw and screw lugs were not large enough to handle this wire size and hold the wires securely once attached. I suspect this will work fine for 14 gauge wires. I'm a bit surprised it was UL recognized for this wire size given the small size of the screw head and ferrule.

Not very good. While repairing the extender, one of the hardware screws that came with this extender was snapped off. It was a screw that attached the wire to one of the contact blades. The fittings are made of very soft metal. The screws come out and all you have to do is insert the wire and tighten. Well I did. But when tightening, the screw turned, but did not tighten, it just broke. I didn't even send it back because of the low price.

Key: The fourth and fifth images show the protrusion/channel that needs to be aligned. Only the green ground screw on part ONE points directly to the duct inside part TWO. If this is a bad key description just look at the photos provided for the product. Country orientation is key. The part with the plastic clip (and two screws) is horizontal when the spare end is placed sideways on a flat surface with the floor in the highest position. In this position, the screw holes line up. Of course, this

I needed a 12 gauge breakout cord to hold my power tools securely so after reviewing them online I decided to make my own. Guyana at a local hardware store and ordered these plugs from Revain to attach to. I was pleasantly surprised by their firm feel when they arrived. They're not as big as the Leviton fork I bought a while back to replace the fork on my 75-foot 14-gauge breakout cable, but they still feel good. breeze. All you need is a utility knife to cleanly trim the outer jacket of the…