🔑 Stens 430-220 Delta Ignition Switch: Top-Quality Performance and Reliability Review

Slightly easy installation and perfect replacement for the mirror image on my Cub Cadet Lt1 Enduro. Not bad at around $36.00 when a factory OEM item is selling for more than double that. The key is not included, but is not required either, as the original still worked perfectly. The attached picture shows the new one installed and the old one I was holding for comparison.

Works great on my Cub Cadet LT-1045! Replacing the old with the new only took a few minutes. Press the tabs to pull out the old part, disconnect the cables, connect the cables to the new part and reinsert. I use the same key from my old switch. I exchanged the part because the reverse mode didn't work on my old one. Now everything works great with no problems!

This part had a different part number than what my 2010 $20-30 less Craftsman LT 2000 needs, I don't think they updated the cross number. so they can take more. The reverse mower worked when it wanted to, so I ended up disconnecting the single wire from the reverse switch to blow the leaves into the woods. If your key looks like mine, then it's the right switch/module for your lawnmower. Stens is a good supplier of spare parts.

Fits and works great in my Craftsman T210 self propelled mower. The mower was less than 30 days old when the original switch stopped working (it turned but didn't work). It was under warranty but the part was taking too long to get to the repair shop so I bought it from Revain and brought it to them for installation. I've only mowed it once since the repair, but it's the right part for this mower. According to the workshop, many of the original switches on these mowers fail.

Seems to work well, appears to be an exact replacement. With my Cub Cadet it was plug and play. Here is my review. I wanted to write this right after the install so that every knuckle scrape, cut skin, and swearing episode would be fresh in my mind. The switch block has four plastic tabs, two on each side. Removal is easy. Push the plastic tabs, which you can feel slightly, and the assembly will pop out. Two sets of cables are connected to it. After removing the key assembly, disconnect these…