🦄 Premium SUPCASE Unicorn Beetle Pro Series Case for iPad 9.7 2018/2017 – Full Body Protection with Screen Protector – Blue Review

View the recommended installation video on the front of the box. It's very easy to install once you do this. The iPad is inserted into the top of a case or screen protector. Please make sure you REMOVE the PLASTIC FILM protecting the front and back top/side of the screen protector first. And make sure there is no lint, dust, etc. on the front or back of the tablet. We have a regular 9.7 inch iPad, not a Pro iPad, and this case fits perfectly! We hope the durability of this case will extend the…

I bought two of these, one for my work iPad and one for my personal iPad. I had no doubts that I would happily pick it up again for my personal iPad as it has withstood my rather harsh working environment. Though I never got it dirty or spilled anything on it (it survived a few tight turns in the car and fell off the dashboard a few times). The stand is great as it can work horizontally on either side. The suggested path gives you a right angle of 70 degrees, and because of the way it's built…

Second review update 8/1/20: I bought a second case for the same iPad because the case has protected the iPad too many times and the front housing plate is cracked. Which is great in a few years because the iPad has been dropped a few times. I didn't want to compromise on the iPad's shock protection and the first Supcase did a great job. The second case is not so good. There was a piece of plastic on the back of the stand and a pin to extend the stand and it broke and I never abused the stand…

So I bought a new iPad 5th Gen and took a close look at UAG and its design. I like the quasi-military hard-book look of Pansonic's design. My first choice was either the new Surface Pro 6 in black or the iPad Pro 12 with a UAG case, but I couldn't justify the high cost of the hardware or the case, although I thought it looked cool. So I got a deal for a refurbished 5th Gen iPad direct from Apple for about $240 and wanted a UAG type case. It was the one best suited for this part. Assembly wasn't