🔧 Enhance Performance: Superlift Suspension 4 Inch Drag Link for 1973-1987 Chevy and GMC 1/2 and 3/4 Ton Trucks Review

Had to use this in a completely different application. It fits my International 1210. Works but as someone else mentioned I also had to buy another tie rod because it was too big to fit in the bipod handle and if I didn't get a lift rudder I would have had to buy 2 tie rods rods. It will work with an 8 inch stroke if you have the steering arm up but the tie rods are pulled out a bit.

It fit my 86 K30 Chevy just like I needed it. I have a 6" jack with a 2" block on the top knuckle bearing to raise the arm. I have exactly the same steering wheel turns in both directions. I couldn't be happier with that.

Had to use this in a very different application. It fits my International 1210. Works but as someone else mentioned I had to use a different one too Buy a tie rod because it was too big to fit in the bipod arm and if I didn't get a tie rod I would have had to buy 2 tie rods.It works with an 8" hub if you have the steering arm on top but the tie rods are pulled out a little.