Pair of Front Hood Lift Supports Shocks Struts Rods for 1991-1996 Camry, 1992-1996 ES300, 1994-1997 Holden Apollo 4217L-R 4217L 4217R Review

Works great, if you don't have a helper to hold the hood, you need to support it during installation, be careful because the small hood is very heavy

This is good quality, same green finish as the Toyota OEM brackets. The picture shows the two sides of the driver, but you will receive the passenger and driver as you should. There is a tab on the driver's side to hold the wiring harness on the brake booster.

Ordered for my '95 Toyota Camry (Japan-built) and they were about a quarter inch longer, the hub went down and tied the hood and pinched it up . I'm not sure if it would be any different on a US built Camry, but I made a few modifications to get mine working.

I rarely leave reviews but love this product - what I expect for $20 - I think I expect it to fit without drilling bigger holes and that Bending sheet metal - with one piece The ball mount makes installation difficult - if they don't last long I'll buy something more expensive that will fit - sorry

They are smaller than original equipment but perform as expected. After installing the left block, I noticed that the metal was slightly bent. (Reason for four stars) I don't think this will affect work, but I'll have to keep an eye on it. Strong enough to hold the hood in place with just one, and with two it works perfectly.

The bonnet supports on my car were factory and could hold a piece of bread let alone my bonnet. I had to saw off my old ones to get the bolts out and once the old ones came off the new ones fitted perfectly and I no longer need a bonnet brace! The picture shows two pillars on the driver's side, but you have a driver and a passenger. Mounting brackets seem a bit thinner than stock Toyotas but can't complain at $20 for them vs $200 for Toyota!