🔧 TASAN RACING Oil Catch Can & Silicone Radiator Hose for BMW N54 335i 135i E90 E92 E82 2006-2010 - Polished Aluminum Reservoir Tank Review

I have ordered this product before and had no problems with it so I recommend it anyway. but the one I got this time was definitely defective. It doesn't seal properly and lets air through like a bad dog, you can hear it whistling in the cabin. I'm pretty sure it's just the result of bad threading because no matter how you run it it will never seat properly which the PCV valve doesn't like and it won't work properly. I would still order them again because I've fitted them to friends' and…

This is clearly not intended for BMW 3/4 series with N20 engine. The silver rim of the connector is too thick and does not fit the stock hose connector. The large end hose is oversized and requires a different size worm drive clamp which is not included. The baffle is on the wrong side, but it can be moved. The included brackets for the latch are not good. You must invent or make your own. You'd better buy a trap and make all the connections and brackets yourself, or buy BMS or Mishimoto traps.

So the installation was terrible. Now remember that I am a mechanic specializing mainly in BMW and BMW Performance. The hose coming from the heater element on the rear turbocharger inlet, it's not big enough, I had to use a lot of heat gun and a lot of pressure for a long time to fit it, nothing should be that tight. Also, the mechanism that attaches to the stand will keep it moving back and forth a lot of the time, there aren't really that many screws that attach there, so even after use it's…

I've tried very hard to be optimistic about this product but its installation is absolutely terrible. The hose is too long on one side and too short on the other side to fit in a suitable mounting location. Does not fit well under the clasp (Zwilling Hamburger Motorsport). What really annoyed me is that you have to take apart the old PCV hose to get the old clips and connect it properly to the PCV ends, that's why I got that because those factory clips broke were, so I thought it will come with

I've been a mechanic for many years, I always build my own screwdriver and an oil catcher MUST be finished in 30 minutes max. This kit comes with a hose that was too small to fit onto the corner connector with the heating element that goes into the air inlet (from the trap to the air inlet). So I went to the local store and bought some silicone tubing, molded it, ok cool, the plumbing is done. let's rise oh, not only were the screws provided the wrong size, they sent two different length…