🔥 A-Team Performance Spark Plug Wire Boot Heat Shield: Premium Protector Sleeve Braided Cover for Cars, Trucks, Hot Rods, and Race Cars – 1,200 Degrees Heat Resistance – 6" Long - Black (8 PCS) Review

What should I wear to keep these things warm I thought they should cool my earplugs In general I am very satisfied, I have to shorten the cables

The metal ring inside does not fit several ignition wire sets. I also drove them for about a week, maybe 100 miles, and it's already burned a couple of spark plug wires, don't buy

Don't buy this to add to your plug wires. It's an absolute pain to climb over the end of the connector wires. If you cut and crimp your own wires, be sure to do so. Durability due to the impossibility of their use:

These things sucked they were all the same length except 3 which were 3 times the length lol it was stupid and then some were sewn like right uh some were only open, frayed ends. I only used 2 of the longest for the worst wires on headers, wish I had a different brand.

Mounted on a Chevy 350 with connectors to keep my cable from melting. This is required when using block manifolds where there is not much space between the tubes and the plugs. These heating sleeves worked great on my 8mm wires, not a single wire has melted since.

First let me say I have the red ones and the first thing that struck me when trying to install them is that the color they are for use, comes immediately. When I put the first wire on my wire my hands were completely red as was my wire. Another thing was that I use 9mm Ford Performance spark plug wires and they don't fit on the 90 degree side with the gray boot. The ring inside is not big enough to put on unless you want to pry the ring off to make it fit. The last thing is that when I rolled…