TheBlueStone 10FT 6AN Nylon Braided Review

Love this braided fuel line. Looks great in my engine bay. I love the extra protection. I used an angle grinder to cut it as steel reinforcement. Quick and quick and loves easy 3/8 clamps.

Just a quality product. I was looking for a replacement fuel line for my boat as the one I was using kept deteriorating. This one is much higher quality and will stand up to the heat and crappy ethanol we ship with. Good product.

Anyone complaining about installing fittings on this type of hose obviously doesn't have the right tools. If you have a soft-jaw vise, you won't have a problem.

Very cheaply made. In fact, I couldn't even use fittings on the line because the rubber kept flexing and the hose was too thick to fit a fitting. Also, as one customer said, the steel mesh is almost non-existent

Had to shave off hose casing to fit my fittings. Used this hose to replace some old conventional braided stainless steel hoses. I got it working and then used heat shrink tubing to clean up the look. For what you pay it's not bad but requires a lot more work compared to other brands I've used.

Excellent hose, works well as shown, be careful of the inside diameter, it is smaller than the nominal dimensions given in the description. Cut the tubing at the cut with tape to prevent fraying. Clamp the hose in a vise with jaws to work around the hose without squeezing it just enough to show it except for the fitting, then grease the inlet fitting and use a wrench or other tool to loosen the Press in the hose fitting with a hammer.