💺 Enhanced Shopping Workbench Furniture with Threaded Casters: The Ultimate Mobility Solution Review

I wanted to make my sim chassis a bit more portable but many of the wheels available are too big and add too much height. These are perfect. They are locked tight. They're small and they're affordable. aces

I got casters for my IKEA OMAR wire shelf and they also fit the RASKOG trolley. They allow me to move the OMAR rack around the garage to sweep it up and then I just brake a wheel or two to keep the unit from moving.

These wheels roll correctly and with the correct rolling force. It's a lot more cost effective to use these wheels to replace the wheels on our laundry cart (which were clogged with hair). All tires changed in 5 minutes.

Every time you apply the brake, there is a permanent dent on the wheel. Apply the brake often enough and you will hear "thump, thump, thump" as you drive it over hard surfaces rolling I would return them but I pre-purchased them for my next project and it's been over 30 days.

Let's be honest these are cheap little wheels - they fit on my GTMega wheel stand which was a plus. 3 of them roll normally, the 4th seems to get stuck on the side. little. I bought these because size was important to me, I wanted something that didn't add a lot of height and it fit. I wish they were better quality and 2x cheaper but these will do.

I wanted this for a project. I have an HF rack for a drill press and wanted to make it mobile and adding wheels was the cheapest way. The kit included 2 nuts for each roller so I didn't have to buy them. I like the caster lock pedals, although I think they should have been a bit bigger as they are a bit difficult to flip to unlock. A larger pedal would give your foot more room for everyday grip. The roller shaft is about 1/4 inch thick and therefore strong. I would buy them again.

I mounted them on a stand for my drill and belt sander. They hold the weight well and are very stable. When unlocked, they move easily and spin freely. My only criticism of these wheels is that they don't have enough rubber surface that the table they're attached to moves easily even when they're locked. They stood across the floor, locked too easily. I wish there were more high friction surfaces around the perimeter. As I don't put too much lateral force on the kickstand it's not really a…

As the name suggests. I ordered a Jarvis bar table with casters and was disappointed when the casters arrived. They're not much different from the ones I pulled from my $110 office chair, you know the cheap plastic construction with a split wheel that likes to get tangled in cords. yes they are The only difference is that all of the chair's wheels are made of hard plastic, while the Jarvis wheels have around 1/2mm of silicon on the tread. Not much, almost none. I decided to return these and get

Four casters keep my freestanding table upright and they started out great, fit perfectly, look great and roll well. I have my 32-inch monitor, laptop, and iPad on my desk, plus the usual desktop accessories, but nothing monstrous or heavy on them. My desk is in my room and only moves a few feet every few weeks to clean or move things. A few months after installation, two of the bolts on the caster broke right where they went into the threaded holes on my bar table. One day I was moving my…