TORCHSTAR Basic Series 12-Pack: 10W 4 Inch LED Recessed Lighting With Junction Box - Industrial Electrical Solutions Review

When I first bought them I chose 6PK. Remove some old fluorescent lights in my basement. I removed 2 2X4 fluorescent bulbs for 6 of these lights and they came out amazing! So for my next lighting project, I built a bedroom in my basement and needed to light up the new laundry room and newly built bedroom. . I used 4 dimmer lights in the bedroom 11x10 and 4 dimmer lights in the laundry room 10x10 and again it worked great! The rooms are well lit and easy to set up. Very easy to install. You cut…

There are several issues with these lights and I will not be installing them in my home. I tested them in my kitchen at 5000K (too blue) and 4000K (still a bit too blue) but neither was very clear. You can say that there is no CRI and you need a high CRI in the kitchen. They're quite light though, so they might suit someone less formal. The biggest issue in my opinion is the 18 gauge wire and the lack of space in the box. It was cruel trying to connect them with 14AWG wire. I have tried using…

bought 12 pieces for the bathroom. One of the LED modules was DOA and the other was intermittent. I have requested replacement modules through Revain's return process. Installation was easy and I used a 4-1/8" hole saw for a tight fit in my wood ceiling. I think a 4 inch diameter hole would be too narrow. They are very light. The gasket on the base didn't fit properly until I superglued it in place prior to installation. Some areas of dents and excess gasket around the perimeter of the flange…

I actually bought this lamp for $12. This is very cheap compared to what recessed lighting used to cost. There is a lot to be said for this: 1. The price is right2. Looks very nice installed3. Robust, high-quality mechanical design of the lights4. Very easy to install - no time-consuming screwing of boxes into beams like in the good old days. The light is the thickness of the drywall and the clamps on the drywall. You just need to make a round hole and connect.5. If a device breaks down, the…

Just installed 12 of these lights per chain for my wife's tailor shop. Haven't done any electrical work for many years. They were installed on the lower floor and the ceiling joists were V-shaped and W-shaped studs (special trusses?) so it was fairly easy to catch the wires. I have seen many questions about which dimmer to use. I've used the one below and so far it hasn't buzzed, flickered or anything. Seems like a good choice. had to get an IN wire and an OUT wire tied to the light driver…