🔌 TronicsPros 4 Pin LED Splitter Cable - RGB LED Strip Connector Y Splitter for One to Two SMD 5050 3528 2835 RGB LED Tape Light LED Ribbon - 30cm/12inch Long (1-to-2 Splitter, White, 1pc) Review

One pass is usually enough, but what if you need two? This splitter gets the job done! Plug it in and you'll share it like a champ!

Trash! First, for the sake of simplicity, the suitcases are attached to the wall from the inside. You can only go around the room in one direction, in a square, so forget about it if you want to put it in a corner. I've spent so much time with them. I just saw it flicker again, I'm done

Error! this splitter did not split the RGB signals to the LED strips as expected. I tested it with multiple controller boxes as well as LED strips, but the blue signal didn't transfer any color to either side of the splitter. Heck, don't buy this product. Nextlux does it better

I had to supply my flashlight as separate kits because the pins in this splitter weren't tight enough. If you had to hang it at an angle like I did, they kept popping up. I gave up and now only use 2 remote controls. Since I keep these lights on 24/7, it's not a huge problem, just an annoyance.

I bought an Airgoo Magnetic RGB kit for my PC and used the strips on my motherboard LED connector because it supports it (MSI 970A Gaming Pro Carbon) which has features that are in the Airgoo kit cannot be found. Then I turned around and bought another Airgoo kit for the same reason, because it has features my motherboard doesn't have. Because of this I had to buy another extension splitter to be able to use 2 more strips. The extension itself is densely covered with very flexible silicone…

I had to put my light in separate kits because the pins in this splitter weren't tight enough. If you had to hang it at an angle like I did, they kept popping up. I gave up and now only use 2 remotes. Since I keep these lights on 24/7, it's not a huge problem, just an annoyance.

The thing does exactly what it should. I'm not changing a star for a few small quibbles. 1- small arrows are very difficult to see. I would like the connectors to only work one way instead of looking for arrows. If you connect them the other way round your LEDs will either not work at all or behave very strangely and for my application this will be used in a pop up camper van which I turn off every time I pack everything up. 2- my other little problem is that the little plastic pins between the

So we bought these for my daughter's room, she had the strips and they came in 4 rolls and as she wanted to walk around the room I had to connect them, this is where this article comes in handy , just cut the strip and, in principle, you can connect them to this element. The only problem I had was that the plug is losing power, since I connect 4 strips, as you can see in the picture the left one seems darker than the right one. We used this in my son's room too, but although his room is even…

I bought an Airgoo Magnetic RGB kit for my PC and used the strips on my motherboard's LED header because it supports it (MSI 970A Gaming Pro Carbon) which has features that make the Airgoo Kit does not have. Then I turned around and bought another Airgoo kit for the same reason, because it has features my motherboard doesn't have. Because of this I had to buy another extension splitter to be able to use 2 more strips. The extension itself is densely covered with very flexible silicone rubber…