Ulincos Latching Pushbutton Switch U19C1 1NO1NC SPDT ON/OFF Silver Stainless Steel Shell With 12V Green LED Suitable For 19mm 3/4 Inch Review

Great lock button. I suggest you know how to solder as it gets the LED working. The first one I got didn't work properly, but Revain replaced it immediately and I was able to finish the job. The LED shines brightly and illuminates my entire cabin. If you want to reduce power, use a built-in capacitor to increase resistance to battery current. I connected this and a similar button in a different color to a series of LED modules installed on the trunk of a Thule XT for my car. The button is…

First of all I really like the look of this switch and it's a nice compact size. However, the test of any switch is how it feels when you use it. A good switch has a nice click you can feel. It has a very short stroke and you won't feel anything, no click, nothing. NO indication that he switched other than the fact that he went to eight inches. The rear connectors are long, but they are very thin and bend too easily. After soldering, place heat shrink tubing over the connectors and tie the…

Purchased when an amplifier is installed in a car. The switch itself feels big, light, and cheap, but it holds up great. It was really a nuisance trying to figure out where to install it semi-permanently in my particular car but without altering major parts of the car. It ended up being a small button panel in the center of the dashboard, but back then that panel even had a circuit board behind the connectors. Thank god there was just enough room on the board so I could dig a hole in the device