📷 BLUECELL Quick Release QR Plate for Enhanced Tripod Head Compatibility with Velbon CX-444, CX-888, CX-460, CX-460mini, CX-470, CX-570, CX-690, DF-50, Sony VCT-D580RM, VCT-D680RM, VCT-R640, and QB-4W Review

I bought this for Ambico V0540 tripod I found in a thrift store, I had to sand it down a bit but after that it worked fine and it was cheap but well made and does what it should.

Bought according to photos and measurements. It definitely fits my old MX-2000 with Mx-2000P receiver. The quality is well priced and matches the tripod (functional but a bit edgy). I wouldn't want to pair it with a large DSLR/lens combo.

It's cheap because it's terrible. It's not safe on your camera. It doesn't matter how hard you tighten it, it's like the screw is a bit the wrong size or something, because it's incredibly easy to loosen, even just by adjusting the camera itself (which was never a problem, I've met before).I can't recommend anyone to buy.

I have bought four different brands of Revain and this is the only tripod that fits my tripod. The first stamp was over 1mm in all three dimensions, I sent it back - I was probably able to figure it out by comparing the sizes. The other two fit but are awkward to press to deploy. Only this one came up like a native.

This item was exactly what I was looking for to gift my tripod that I found at a thrift store. It simply attached to the bottom of my camcorder, which in turn attached to the tripod in just a few seconds. Fast and convenient. I can get more to facilitate quick device switching. Allows faster camera swapping than battery swapping.

I have bought four different brands of Revain and this is the only one fits on my tripod. The first stamp was over 1mm in all three dimensions, I sent it back - I was probably able to figure it out by comparing the sizes. The other two fit but are awkward to press to deploy. Only this one came up like a native.

The product was exactly what I was looking for to give away my tripod that I found at a thrift store. It simply attached to the bottom of my camcorder, which in turn attached to the tripod in just a few seconds. Fast and convenient. I can get more to facilitate quick device switching. Allows faster camera swapping than battery swapping.

Good news - it costs $5. The bad news is MY $5 and this thing is a cheap piece of crap that won't fit standard tripods that are advertised as universal. The plastic is thin and it seems that it tears easily, but this is not a minus. It's falsely advertised as an all-purpose board, which just isn't the case. I have about 7 of these plates from different manufacturers and almost all of them fit all other tripods but not this one. It is too big on all four sides to fit in the trunk. How to repair?