🚗 KEMIMOTO Universal 12V Car Windshield Washer Pump Kit with Button Switch - Windshield Tank and Washer Fluid Reservoir Bottle Compatible with Polaris RZR Ranger General Review

The plastic is stronger than I expected but the black part is plastic not metal. So the bracket will flex a bit if you only have one bolt holding it in the OEM position like I do on my Jeep YJ. The pump works well, the atomizers are better than my factory atomizers but they don't match my car but that's to be expected. Good value for money, the tank holds approx. 500 ml.

It was my decision to fill the household batteries in my camper. I replaced the caps with monitor caps with a 1/4" filler tube on each battery cell. I attach a hose to each cell, attach a container of distilled water to the battery and turn it on long enough to fill it. Preferably not by hand, I don't have room in the compartment to fill them in any other way.

Fits exactly on a 1996 Fleetwood Pace Arrow Vision on a Ford F53 chassis. Even the Ford electric plug fits and almost fits into the bracket but is too tight so the supplied plug is used instead. Filled with RainX, pressed the wash button on the turn signal, and it hit the windshield perfectly. In terms of durability I gave it five stars because it felt as thick as the original but only time will tell.

The entire unit was purchased for much less than replacing a failed pump. All concerns vanished once the unit was installed and the pump provided better pressure and flow than the original unit ever did. New replacement jet nozzles were supplied but the equipment was hooked up to the originals. I should have ordered this replacement years ago when the original pump first started leaking well before it completely failed.

.and no wonder why. The second arrived in a flimsy thin OEM box with a shipping label. There is no packing tape anywhere. The valve/lid opens when you turn the box upside down along with the contents. Unforgivable shipping/packaging job. Otherwise a quality part. Comes with lots of mounting hardware and plumbing. All I had to do to install it in my 1997 Damon Daybreak (Chevy P30 chassis) was connect the wiper hoses and electrical connectors.

I installed a hose on my Jeep XJ and had to remove the factory washer fluid reservoir. This is a good alternative. Easily found a place for it due to its size, but I have a lot of liquid due to its size. It's a compromise but overall a good product, just keep a gallon of fluid in your car and you'll be fine (add it if you check the oil every time you fill the gas tank as the owner's manual recommends, I know you don't and so blow your motor) hooked it up to the factory wiring harness for my old