🚗 USCAN 3013100601 Black EZ Pass Toll Tag Holder - Convenient and Durable Solution for Toll Collection, 1 Pack Review

This new improved EZ Pass holder is almost completely useless. I've had two previous Stick models and they work really well. First the suction cups were glued to the packaging. The top layer of packaging left marks on the suction cups after peeling off, which had to be removed with a solvent. Second, the holder is too big to fit behind the rear view mirror. There must be a better design and packaging for this product!

Great product so far. It definitely fits my old EZPass transponder and definitely beats the velcro straps which don't hold at all. My husband absolutely needed this SUV for his work. I've usually had to press the transponder against the windshield on long up and down 95 rides, plus it's supposedly rude to do it now, but when EZPass gives you flimsy glue, what do you expect? Problem solved and that was the ticket!

Although this tag holder is roomy if not bulky, it securely holds my small 2015 Maryland transponder. I was able to place it in a position where my mirror would hide it. Although I have read some negative reviews of the holder falling out of the car, so far the holder has been reliable in moderate to hot weather. Perhaps the reason for my success is that it holds securely because I first washed the window with glass cleaner and then attached the suction cups to the wet surface.

I liked this product because it wasn't that expensive at the time of purchase. BUT now I come across a holder that blocks the reading of the transponder. I was driving over Burlington Bridge to Bristol Bridge and the handle would not open and the worker there had to scan it and say the problem was with the holder. I don't need velcro (which I didn't want to use) as it blocks reading of the transponder. I don't drive on toll bridges or toll roads that often. I want to return this item, but…

Great idea to get rid of the sticky, dirty and unreliable velcro system that attaches the EZ-Pass to the windshield. The problem is that the transponder is much thinner than the space allotted for it, so it tends to rattle inside the tag holder. I fixed this by using small dowels on each side as spacers. In addition, the position of the suction cups allows the label holder to rotate and hit the windshield. I had to add a foam strip at the bottom to soften the impact and annoying clicking noise.

Holder suction cups withstand extreme temperatures. I have a VA EZ and the holding block is slightly larger than the EZ block. . I left all the adhesive strips on the pad, didn't peel anything off and "wedged something". Then it holds well, nothing rattles. My advice: check out the reviews and make sure the holder is the right one for your state, as many reviewers point out. I find it easier to keep the device and mount together and put it in the glove box when not in use. Since I'm not a daily

I have purchased two E Passport window mounts from Revain. Both said they fit all the latest models, but none of them fit mine here in Florida. While they were normally attached to the disc, one did not hold the e-passport transponder at all and the other held it loosely and did not allow the sensors at the entrances and exits to read it. This means that I will now be charged a premium rate and a printed invoice will be sent to me at the end of the month. And this despite the fact that both…

Holder was purchased to easily transfer our New York E-ZPass tags to rental or other vehicles temporarily. After looking through lists of Revain label holders, I found that too many of them seemed prohibitively expensive for this type of item, or many of the reviewers found the design poor or cheap. Various reviews noted that over time some of the windshield mount suction cups either held poorly in hot weather/climates or simply did not provide a consistent grip at other times. Others seem to…