🔩 Uxcell 2mm x 5mm x 2.5mm Shielded Miniature Bearing - Power Transmission Products Review

out of 10 only six (6) were good. One was fully caught and three rolled very hard. The worst thing is that the hole diameter is just under 2mm. I have 2mm thick stainless steel shafts which I measured with vernier calipers and found 1.9mm. The bearing bore is a bit narrow and I can't get the shafts into the bearing securely without a lot of force. The diameter of the hole is about 1.8mm to 1.85mm based on my estimates. That being said, it's pretty hard to find 2mm bearings for less than $20…

Like my reviewer, I bought these to repair 1407 quads. As the stator and bell were in good condition this should be an easy bearing change. Right? Well I actually went back and bought a second pack after having trouble with the first one. I assumed it was my fault because I didn't know how brittle these bearings really are (have you seen the balls?!). This time I made the right tool to mount the bearings. However, I still had about 50/50 positive results. I went through 4 camps before getting a

Poor quality bearings. Bought to fix two ATV bearings. When I replaced them, the motors sounded just as bad as when they first started. I know I didn't damage the bearings when I installed them because I slid them into place with no tools, just my bare fingers. But the real problem came later. I tried to remove the built in bearings and they literally fell apart in the process. The outer clip has become one with the motor stator housing. I probably could have taken it off with more effort but…