🔌 Vertical Bulb Trim Seal - Bulb Dia: 0.5", Grip Range: 0.039" - 0.14" - Rubber Seal for Trunk, Boot, Lid, Hood, Hatch (10 Feet) Review

Purchased for aftermarket service on my car. The strip fits very well on a thin air intake panel. Also, it was very easy to crop.

Good pressure. Seems solid. For some reason it wouldn't stop in one direction for my application. But a 180 degree turn helped. Durability? Only time will tell, so far so good.

A solid product that works as advertised. I used it to seal the top of a special air box on my race car's closed hood to keep hot air out. It took a bit of effort to apply, but that should mean it stays in place.

Required to seal the boot lid window on the tailgate. Provides 100% effective water infiltration and even helps to securely close the window and reduce vibration. The handbag works exceptionally well. I was planning on using silicone sealant to glue the gasket in place but found it wasn't necessary.

Needed to replace the gasket on the AFE Magnum intake manifold on my 2002 Ford Excursion 7.3 Limited. Compared to a $30 AFE replacement, that's not even an issue. The only thing I did to make it fit perfectly was make the 45 degree cut just on the inside of the print band and voila! Fits perfectly. Highly recommend this app and save a few bucks! Highly recommended A++