🏍️ Powerful VM22 26mm Carburetor Carb Replacement for 125cc 140cc Pit Dirt Bike Lifan YX Zongshen XR50 CRF70 KLX BBR Apollo Thumpstar Braaap Atomic DHZ SSR with Air Filter Intake Manifold Review

It was as easy as unscrewing the old one and screwing on the new one. The only downside is that I didn't have the nuts and bolts so I had to buy them at a hardware store. For Hellcat 125 use it with uni pod filter and 115 nozzles.

Fits our KLX110 but cannot use the included air intake or airbox as the frame gets in the way. I also had to run to the hardware store for M8x1.0 nuts as the carb body was unthreaded. However, once I got the bike started it actually runs fine, much springier than a warmed up carb that was replaced.

Amazing upgrade for my SSR 125 pit bike, bigger carb so you get more air/fuel which improves performance. My old carb screwed up, hooked up this Macuni and fired up the first time. Make sure you do some tweaking, you want it to be richer rather than leaner as this will cause the engine to heat up more and break.

According to the description it fits Apollo 125. Not true. The intake manifold is wrong. The additional collector in the kit does not fit at all and is not installed at all. The air filter has no air inlet. And the worst thing is that it doesn't keep running because the idle adjustment screw is completely out of order. It moves, but when idling it doesn't change at all. I will not buy again.

The carburetor is very easy to install. This gave a much larger throttle range. Very important. Now for the person whose gas was pouring out of the bottom of the carburetor? You must install the fuel line in the right place. This is a nice shiny hole for fuel to enter. You can also purchase different sets of nozzles for different purposes. This carbohydrate is great. Please don't knock if you don't know.

Worked great on my 2005 klx 110 which did some reaming, had to remove old choke and replace bolts, no threads in manifold, just had to add nuts on back, son didn't put riser in , the carburetor is not straight and interferes with the plastic. Just remove a screw and the plastic support and it fits great. The carb sits a bit to the side, not very straight, but the bike screams now, so I've decided to give five stars My 2013, which now has a clutch, smokes from the power alone. It is now possible

Slightly more expensive from this seller compared to all other sellers with the exact same product. However, my air filter was damaged - as it's on a motorcycle I decided to just discard it, hoping it wouldn't cause me any problems. When I disassembled the carburetor to replace the pilot/main jet, the rubber gasket inside the carburetor itself popped out easily and I had trouble sealing it. I bought a new set of carburetor gaskets. I wrote to the seller about the problem but received no…