🔧 High-quality 8 Pack WD12X271 Dishrack Rollers for General Electric Dishwashers - Lifetime Appliance Review

Printed exact dishwasher make and model and it was an oversized wheel with under bored, doesn't fit. You're trying to return and don't seem eligible for a refund. Do not trust the accuracy of the information

Works, easy to install, seems durable. They fit a little loose but seem to be holding up with no issues after two weeks of use. UPDATE: Almost two months later and they are working well so far. No problem as I replaced original parts that were falling apart. I would buy this again if needed.

After installing the axle pins the product will be great. I've found it's best to run them under hot water with needlenose pliers until the plastic softens a bit. Then gently squeeze the tip of the needle as you slide it through the hole in the axle. Once that's done, they work amazingly and at a low price!

I replaced the wheels on my GE Triton XL and they are thicker than the original wheels so I feel they are a bit tight when pushed all the way in. (But not enough to cause a problem, it's barely noticeable.) Other than that, I like them better than the original wheels. The reason for this is that the originals rotate to snap, making them more likely to fall out during normal use. These new ones snap to the side so they should never accidentally pop out during normal rotation.

These would be a great purchase as replacement wheels for my dishwasher if they really fit. Outwardly, they look exactly like the factory part - the problem is that the clips are overmoulded and fall off almost immediately. This is quite frustrating as it is a simple part and a slight modification of the clamp shape can result in a satisfactory part replacement. I'll try to heat and recast the clip to factory defaults (if that doesn't work I'll try to "build up" part of the DV basket to make…