🚗 Weigesi Automatic Transmission Pedal Foot Pedals Brake Gas Pedal Cover Trim for Mazda CX-3, CX-5, Mazda3, and Mazda6 (2015-2020) Review

The gas pedal is easy to install and stays in place. The footrest I think should be taped to the carpet. It's not very durable and the only issue it hasn't solved is that I have high lipped all-weather floor mats to keep it in place. The brake pedal was a challenge. First you have to remove the existing brake pedal cover, which isn't too bad, but fitting a new cover is awful - the rubber is too hard to get on easily, or maybe it has too much lip and not enough tolerance. Once worn they look…

I never liked the floor mat on the 2019 Mazda CX-5. This set of pedal covers worked well. On the 2019 CX5, the accelerator pedal cover simply slides over the existing accelerator pedal. For the brake pedal, the existing rubber brake pedal must be removed before a new cover can be fitted. The dead pedal is attached to the carpet with adhesive strips. I added extra carpet tape to secure the flat dead pedal board. In general they appear to be of good quality. There were no instructions in the…

I would give this set 5 stars if I could fit the brake pedal cover. I can do that better when summer comes and the rubber becomes more elastic. In winter it was not possible to put on the brake pedal pad. I even had trouble removing and replacing a Mazda OEM brake pedal cover in the winter. The gas pedal cover comes off in 10 seconds or less, and its added thickness actually makes the gas and brake pedals easier to work with when using a typical heel. and tip your right foot to step first on…

Excellent combination of price and quality! As others have said, you should probably get some velcro tape for the dead pedal (footrest) as the pre-installed adhesive strips will likely lose their stickiness after a while. Also, the brake pedal is a bit painful to press. Just walk slowly, starting in the top right corner, and moving in circles. Make sure the edge on the outside goes all the way around. I could do it with my fingers but a small flathead screwdriver or trim remover would…

These pedal covers are great. They fit perfectly with my new 2019 Mazda CX-5 Signature. The accelerator pedal cover is placed on the existing pedal cover. The installation literally took 10 seconds. The brake pedal cover needs some tweaking, but it's also pretty basic. The trick is to make sure the rubber backing is warm so it can stretch. First remove the original brake pedal cover. Then start at the top right corner of the metal brake pedal and make sure the new pedal housing is plugged in at