Header banner
Revain logoHome Page
πŸͺš wen 6510spc spindle sanding assortment logo

πŸͺš WEN 6510SPC Spindle Sanding Assortment Review




Revainrating 2.5 out of 5Β Β 
πŸ› οΈ Abrasive Mounted Points, πŸͺš Abrasive & Finishing Products

View on AmazonView on Π―M


img 1 attached to πŸͺš WEN 6510SPC Spindle Sanding Assortment
img 2 attached to πŸͺš WEN 6510SPC Spindle Sanding Assortment
img 3 attached to πŸͺš WEN 6510SPC Spindle Sanding Assortment
img 4 attached to πŸͺš WEN 6510SPC Spindle Sanding Assortment

Description of πŸͺš WEN 6510SPC Spindle Sanding Assortment

Includes six 80-grit sleeves, six 120-grit sleeves and six 240-grit sleeves. 1/2 in. 3/4 in. 1 in. 1-1/2 in. 2 in. and 3 in. spindle sleeve for each grit. Perfect for material removal, resurfacing and more. Designed to fit the WEN 6510 Oscillating Spindle Sander.


Global ratings 3
  • 5
  • 4
  • 3
  • 2
  • 1

Type of review

Revainrating 2 out of 5

Great quality and fit Rigid sander

I'm a handyman and the spindle sander is one of the main tools in my workshop. These are really good sanding guns, especially for the price. I use home stock Diablo brand sleeves (my machine is a Ridgid belt/spindle sander) and they're great, but you can't get an extra fine grit there. I received and used it today and am very happy with it. Tip: Use one of these rubber sandpaper cleaners often and they'll last quite a while.

  • Perfect for stripping, sanding and more
  • Out of fashion

Revainrating 5 out of 5

Grits are not as advertised!

80 grit seems much coarser than 80 grit. Should be 60 grit or something. There was no 240 grit, mine had 2 sets of 120 grit. I build guitars and basses and I really need to be able to sand down the bodies of the guitars that I build. The wood must be sanded to 220-240 grit to allow the abrasive compound to penetrate and lift the fibers before the top coat is applied. Now I have to order a separate set of finer grit bushings. There was no way to contact the seller with them and they are from…

  • Designed for WEN 6510 orbital spindle sander
  • Not automatic

Revainrating 1 out of 5

Poor fit on HA-5932 WEN

I have purchased a WEN 5932 orbital sander which can be used in manual mode or mounted on a table with the brackets that come with it. While the sander and included sample bushings work great, the additional grit bushings I ordered were too long for the spindle drum and I had to cut off about 1 1/2 inches to fit. The problem was the loose fit. The bushings slipped and pulled away from the spindle no matter how hard I tightened the locknut and no matter how carefully I installed the washer. This

  • 1/2", 3/4", 1", 1-1/2", 2" and 3" grinders. Spindle bushing for each grit
  • High price