🔧 Werner 55-2 Attic Ladder Hinge Arms Replacement with Enhanced Compatibility for 2010 & Later Models of Werner Attic Ladders Review

The product lacked the hardware to mount it and was returned. The price is too high, the springs had to be bought separately. Customer service was unsatisfactory.

The bracket was slightly different from the original but fit the old holes and worked great once installed. The Revains mount was a better fit for replacing my old attic ladder than Kentucky's own ladder.

When I bought this item I knew it was just for Werner. I have a Century floor ladder and couldn't find the right levers for it. I was able to get this to work, I had to move the mounting studs up the ladder to make it work. Payment and installation of a new Beats attic staircase.

was just the right size. and it comes close because the spring holes are too wide. Tries to drill new holes and you can only drill as much as needed before the lever hits the snap hook. did what I did and there is still a 3 inch gap.

My old rod had a different mount but the new one fitted perfectly. The instructions for removing the old set were "good" but the instructions for installing the new set might offer some alternatives. I found the instructions for placing the new retarded bolts in the same places as the old ones to be a bit absurd since the rest of the rivets were still in place. Therefore, I turned the plate and drilled pilot holes so that the functionality of the connection does not change. After completing the

Before purchasing this set, I have paid particular attention to the comments previously given in the reviews section by Mr Thorpe, Mr Sparks, Matthew M and Mr Putnam. I had them and compared them to the advertised values for this device. My arms were different as they didn't include the curved part, but simple math led me to conclude this would work since all other measurements matched. My staircase was very old and there are no visible traces of who built it; So there was some risk in buying…