Winco Cutting Board 1 Inch White Review

The thickness of this cutting board is stated on the website and even on the label on the board. As you can see from the photos, this board is about 1/2 foot thick, and the stated 1 foot thickness is a far cry from what it claims. He comes back.

The boards are solid but only 1/2 inch thick as shown in my photo. I was hoping to cut them in half and make 9 x 12 RV pads. I didn't return them as they seem solid even at 1/2 inch so I'll try.

Used to mount a trolling motor on a boat instead of starboard which is outrageously expensive. ($400-600 per sheet). It works the same, I cut it to a custom size and it saved me hundreds of dollars. Very strong, has been serving for half a year and still no complaints.

This item is amazing. I bought the board with no intention of using it to cut food (yes, I'm as guilty as anyone who saw the opportunity). I used it as a base for a bench drill so I could easily take it with me and use it anywhere. The weight of the board makes it very stable when I'm working with a drill press. but this board is suitable for my purposes on T.

I've been looking for a 1 inch thick cutting board for months and was thrilled to have it back. I needed something permanent and was shocked to find it wasn't as advertised. Although strong enough to cut, I can bend it with my bare hands and is not suitable for my needs. You cannot contact the seller directly, and while Revain is helpful, they cannot verify that the supplier has 1" thick panels. Very dissatisfied with false advertising.

Although this product is actually *cutting board* I needed special plastic to make an engine mount for our V-8 Yamaha on our pontoon/tri cartoon to produce . I cut, shaped and shaped the two pieces and then glued them together. Then I drilled holes for the power trim hydraulic rods. It runs flawlessly and now supports that 700 lb motor perfectly. Ordinary plastic sheets of this thickness are slightly more expensive. So it was a great deal for pretty much the same type of plastic.

Like a few others, I didn't use it as a cutting board at all, instead using it as an inexpensive way to get my hands on 1-inch plastic. I used it as a base to mount a cellular antenna on an RV. The plastic was a solid base against crosswinds (when "up"; the antenna can be lowered for travel) and appeared to be of good quality. I drilled four holes to mount the antenna by slowly lifting my drill to avoid tearing the plastic, the plastic held the drill well. I used a larger bit on the end to…

Like some other reviewers, I didn't buy it to use as a cutting board. I needed a 1 inch thick piece of plastic to seal under the car battery. This item was a lot cheaper (and easier to find) than buying raw plastic of this thickness. I cut it out on a table saw and it works great for what I needed. I'm sure it will work as a cutting board. Really very durable. If, like me, you're buying for other purposes, there's one small thing to note. Thickness varies slightly. The edges were 1 inch, but…

Item shipped and received in just 3 days. This 1" HDPE cutting block was used to raise the deck height of a hand winch to retrieve the rear anchor and raise the boat. "(Actual size 11.75" x 17.75"). Its cutting faces are embossed with flat diamond patterns to help chefs secure the board. This material is easy to work with in marine environments. Drill with lower speeds and cutting multiple passes with thin blades gives very precise cuts. No overheating effects were observed with standard…