Cuts raw oak like hot oil, doesn't fum the wood and makes straight cuts. Don't forget to relax your blade tension when you're done with your day at the store!
105" blade can come loose even if the tensioner is full on a 105" reaction bandsaw. I would have to cut about half an inch and re-weld the blade to make it work. But most likely this blade will be on the shelf, and I'll just order a wooden grinder, which is even better.
Blade seemed sharp enough but didn't last long. I have several third-party 3/4 blades that I used until they became dull. This blade broke at the weld after only a few minutes of use. The saw I run it on is the same and the tension is within the manufacturers specs. In addition, it was cut with a high fence, so there were no problems with tying. It's just not the best design. Therefore I will not buy this product again. Sincerely, Jim