🔥 Maximizing Performance at a Low Cost: XiKe 20X42X12-mm Pre-Lubricated Power Transmission Products Review

I need to replace my bike's crank bearings that were flooded during Hurricane Dorian last fall. The grades on existing bearings were 6002 RS. Almost all the spares I looked at were 6002 2RS which were stated on several placards to be the same 32 x 9 x 15 (mm) size. Since RS is supposed to stand for Rubber Seal, it made sense and I agreed. These bearings came quickly and at a good price. I only needed 2 and many listings were for packs of 10. Unfortunately the bearings are not the same size as…

Used to replace 2 bearings in rear brake pedal for KTM off-road motorcycles. Accurate measurements but very poor quality. After ONE smooth 43 mile ride on dirt roads with few puddles, I went home to inspect my pedal as there was little side traffic. After making sure the pedal was properly attached, I removed it to inspect the bearings. Without removing the bearings from the pedal, I pressed on the protruding seal and noticed tiny drops of water appearing between the outer ring and the seal. I…

I tried to use these 6003-2RS bearings in a pressure washer. The bearings probably deserve 5 stars but how am I supposed to know. Nowhere in the description does it say they won't work in a humid place. The photo I posted is after 2 sessions of using it in a pressure washer surface cleaner. I bought an ASIN B01BMB3X68 surface cleaner and immediately replaced the original bearing which differs from other reviews, I wish I hadn't because now I can't compare the usability between them. But with…