💥 XPG SPECTRIX S20G 500GB RGB PCIe Gen3x4 NVMe 1.3 M.2 2280 Internal SSD - Lightning Fast Speeds of 2500/1800MB/s Review

I like RGB and the speeds are as advertised. I have an ASUS TUF x570 Wifi motherboard with Aura Sync which should be compatible, but with Aura Sync enabled on the XPG S40G my speed drops by half. When I turn it off, everything reverts to the stated speeds. I have the latest firmware for XPG S40G and Aura Sync. I'm not sure who to point the finger at or where to start with support, but I can confirm that this issue only occurs when Aura Sync is set to sync the light on my XPG S40G controls. This

Update 3: So I ordered 2 units (1 for me and one for someone else) My unit (unit 1) failed the simple cloning and caused a short circuit which messed up my pc a bit and i was sent block 3 as a replacement, block 2 still works so i bought my block hoping to improve my computer a bit before the holidays although it was a bad experience. on 2 and mixed bad and normal on the last one. Block 1 burned out (due to motherboard/RAM issues after shorting itself out had to reapply the profile) and now…

So I bought it mainly because it was about the same price as most non-RBG discs due to the coupon. I wouldn't normally bother with RGB, but I shrugged and thought "why not?" It was a mistake. After a short boot time and switching on this drive, the idle temperature rises to 50 C°. Now my other Adata M.2 (XPG GAMMIX S11 Pro) stays in standby at 38-40 C°. Now notice that this is with RGB OFF! When I start doing light tasks, the temperature is 53-58 °C, and when I start playing games, for example,

I like RGB and the speeds are as advertised. I have an ASUS TUF x570 Wifi motherboard with Aura Sync which should be compatible, but with Aura Sync enabled on the XPG S40G my speed drops by half. When I turn it off, everything reverts to the stated speeds. I have the latest firmware for XPG S40G and Aura Sync. I'm not sure who to point the finger at or where to start with support, but I can confirm that this issue only occurs when Aura Sync is set to show the light on my XPG S40G controls. This

Update 3: so I ordered 2 devices (1 for me and one for someone else) my module (module 1) was basically not working and causing level cloning a short circuit which messed up my pc a bit and i was sent block 3 for a replacement, block 2 still works so i bought my block hoping to give my pc a little boost before the holidays, so far it has been one bad experience on 2 and mixed bad and normal on the last one. Device 1 burned out (caused motherboard/RAM issues after shorting itself out had to…