🚙 Top-rated Xprite Replacement Headlight Brackets for 2007-2018 Jeep Wrangler JK Review

Installed Sat. Driver side is ok but Psngr side is not. 1 of 3 snap clips is already broken. and send replacement. Love this product, goes well with my aftermarket Halo LED lights but must have been a bad latch/connector. Great email customer service and worth the price for my 2013 jk.

NOTE ---- The customer service representatives are great and when we raised the issue they said they were aware of the issue and would fix it during our call. I received a full refund and will be notified when the product is back so I can make another purchase. Become a regular customer. The fact is that after putting it on the jeep, the plastic opens more than necessary, making the headlight loose. Must be reinforced with some kind of metal or something. Once in, (just like in the video) you…

I had broken right braces and they fit well. Stock headlights, like most, are illegal, but get the brightest you can. All 3 tongues are broken on the old one. I carefully snapped the 3 tabs onto the pin and then reattached the headlight (damn short wires!) and then placed the bulb, lining up the 4 tabs on it and taking my time to make sure everything was flush when I tightened them . Zero miles so far but everything was going pretty well, some jigs seemed a hair's breadth from the OEM but close

They are good quality and strong but WARNING they fit the same as stock rings! I ordered them to work with some of the new LED headlights I bought and they fit exactly as stock. The bezel on the passenger side is slightly inclined on many LED headlights and does not fit into any of the recesses. All you have to do is cut the notch further so that the headlight housing sits correctly in the ring. One star deducted because they are said to be required for all aftermarket LED headlights but have…

Installs exactly as shown in the video. In fact, I went a step further and removed the adjustment screw instead of putting a clip on it. The only solid post is the one I removed and then screwed into the hole. The other clamps are completely loose and the lights are loose. This happened on both rings. Update: OK, this is what you need to know when purchasing. When you snap them into place, they should not be flush with the rest of the headlight housing behind. There is over half an inch between