🛠️ Enhanced Yakamoz Tongue and Groove Woodworking Cutting Tools for Optimal Milling Review

As an avid woodworker, I was excited to try these Industrial and Scientific cutting tools. However, as my tests showed, the results were nothing short of disappointing. While they may work for some basic projects, I found that they struggled with more intricate cuts and left behind rough edges. The only pro I can say is that they were easy to set up, but unfortunately, that cannot outweigh the cons of their lackluster performance.

Very satisfied. Used to install mdf in zylltech tslot and it worked great. People have complained that the shafts on some of these non-genuine bits are bent, but I've had no problem using them with my Bosch plunge router.

Good for those having problems with shank bending and broken cutting tools, here is the solution. Change the shaft length. The shank of the drill should not protrude more than 1/8" to 3/16" past the collet. Those tails were too long for both of my routers. As shown in Figure 4, I used a dremel to remove 1/4 inch from each shank, which allowed the bits to fit properly in the collet. I used them for T&G on both ends at 386m². They're sharp and clean but remember to keep them sharp. I haven't had…