High-Quality 3Pcs Sensor Kit for Nissan & Infiniti - Camshaft Crankshaft Position CPS 23731-AL60A 23731-AL61A 🚗 23731-6J90B - Compatible with 350Z Altima Frontier Maxima Murano NV1500 NV2500 Pathfinder Quest Xterra - 3.5L 4.0L Review

Bought because the price was good - disconnected battery, removed old sensors and installed these. I immediately received CEL codes for the camshaft and crankshaft position sensors. Both pending and current DTCs for both. Ordered OEM parts from another supplier (Nissan) - installed and codes gone. Save your money and get an OEM - it won't work and you're wasting time, money and a lot of effort.

Installed on my '05 G35, worked fine except bank 1 but car started and still runs but takes a little longer and the engine/slip/VDC light is still on. A week later I noticed an oil leak around the sensors. Check the o-ring sizes and they are slightly different, about 1/16" from the OEM. I'll replace them with other versions and maybe get a larger o-ring as that's pretty cheap to make too. You see, what you pay for.

I am ordering this kit with 2 position sensors for the camshaft and 1 for the crankshaft. First installed on the car, the engine runs fine, but after installing the crankshaft sensor, the engine does not start. Return the old sensor, the engine will work better, but it still won't start. If you run into the same problem after installing all three, replace the crankshaft sensor with the old one to see if it works, then buy a new one somewhere else.

Sensors arrived on time, in excellent condition and worked perfectly. One or two are easier to install than the others, but THEY WORK! After all, that's what I need. There is no need to contact the seller as he got it the first time. My truck runs in tip-top shape and my "Motorservice" light went out shortly after installing these sensors along with other parts I purchased from them. GREAT WORK, GREAT SELLER!

I bought all 3 sensors although I think I only need 2 of the left and right sensors, the left one doesn't connect fully so the connector clicks and locks. I measured the key one way and the replacement is slightly shorter and this is causing it not to engage. The bad news is that I probably needed it. I knew that at $28 they would be junk and wouldn't last long, but I figured they would pocket at least and last a year. I got what I paid for to save time and just bought it at an auto parts…

Once you figure out where they go. It's easy to install, 2012 Frontier 4.0 just shuts down every time for no reason, might turn on again, or just die completely. Camshaft sensors not working. don't think i had a problem there, swapped them out anyway, drove them and still had a problem, the next day the crankshaft sensor came on so i replaced it with the one that came with it, didn't work at all, truck kept moving off on off Not. Had to buy one at the local parts store, paid 72.00 for it, now…