🛴 Z-FIRST Pro Scooter Pegs - CNC Aluminum Pegs for Stunt Scooters with Hardware, Enhanced SEO Review

Cannot rate 0 stars. The color is beautiful, but the technique is complete nonsense. Maybe the Chinese have a thinner type of socket or wrench that we don't know about. Couldn't they make it a little bigger to fit in the nest?

Outstanding pens; You can ride it both front and back, one front and one back on either side or side by side. I also have an Envy roller and they fit great, I've been using them for about a month now. For more fun and stunts I would suggest you both put on the front wheels.

Installed on a Prodigy Envy. Good quality. Would give 5 stars but the screws are too long. I had to install spacers so the screw wouldn't stick out too far and hurt. Also, a screwdriver had to be used to wedge and tighten the nut as there is no room for a wrench or socket. You should use a two piece bolt like the one that comes with most scooters so you can use two hex wrenches and tighten it.

Apart from what others have written above about the standard 13mm socket not fitting, the once silent toy now makes a loud clicking noise once mounted on a Fuzion scooter is. Was a headache to install and wouldn't recommend it. However, if you still buy them and want to install both on the same axle, make sure you have a flathead screwdriver to hold the nut in place during installation. VERY DISAPPOINTED.

Absolutely worthless. The screw in the kit that needs to be tightened inside the pin (item 13) cannot be tightened. he is not there. 13 socket that can fit in the pen! I should have read 30 other reviews saying the same thing. What a waste of time. How does Revain still sell it? Aggravating. Check out my photos and videos.

Installation on a jealous foal. First, the hole in the pin is too small for a 13mm head. After asking everyone we knew if they had a thin-walled rosette, our artisan uncle had to carve the outside of his rosette to make it himself. But that's not all. After tightening it, we found that the screw was either too long or there wasn't enough thread to fully tighten it. So we had to drill out the threads from the extra nuts we found as washers to thread them all the way through. It was a real puzzle

Purchased for the Madd Gear Shredder. Removed plastic deck blocks to allow landing. The narrow cylindrical end of the pen is not long enough to fit in the spine - too wide to fit. For this scooter you need to buy a longer rear footboard. Not sure if it will fit other Madd Gear models. I decided to put her on the Envy Colt. The pins fit, but the front bolt is too short (about 2 turns will hold the nut). The rear bolt was too long so you could injure yourself if you stick out too far. I had to…

They look good, but they're hard as hell to work with. Inside the pin are the bolts and nut, and it's difficult to find a socket thin enough to fit in there but still fit the nut. I think they should be made to bolt onto existing bolts or somehow just be hand bolted on rather than requiring separate nuts and bolts to install them. We like the way they look but we are very happy with them. If I hadn't scratched them while putting them on I would have sent them back. I highly recommend not buying