🏍️ Enhance Style and Protection with the 5 3/4" Black Aluminum Headlight Grill Cover for Sportster Roadster XL1200R XL883 883 Custom XL883C/XL1200C Low XL883L/XL1200L Iron 883 XL883N Review

Easy installation. Installed in parallel an aftermarket LED headlight. You need to cut, disconnect and pull out a few zip ties to install the back of the grill and then just reassemble it.

Generally a good product, came with scratches and chips but didn't want to wait for another. Installation was not easy and there were no instructions. But overall they fit and look great. I would buy again.

I thought it would look cool on the bike I'm building but couldn't tighten or hold it. I stayed around for a few hours. Maybe I'll try it another time with a different bike. Or maybe not.

Just be careful when tightening the frame. And when installing, hold the headlight slightly to the left so that it perfectly matches the grille on the last pull. It is better to rotate both forward and backward to keep straight alignment.

This product was easy to install. Just twist it to take it apart, then all you have to do is turn off the light, maybe grab a zip tie and that's it. It feels really lost in the beginning. You just have to keep turning it to tighten the headlight. Overall the product was great. It makes a big difference to my bike.

A lot of people have left bad reviews. I think it's just because they don't know how to install it. I have two headlight bezel clips on my Sportster 02. I replaced the front clip with this headlight grill and the headlight is still rock solid and fits great. 10/10 can't believe it was $20

Great addition to my 2016 Harley Sportster 48! This made the entire front end of my bike look different. Some said it was difficult to install or not tighten. I had no problems with that. You don't have to remove the stock headlight or wires to install them. Simply remove the headlight ring, then put everything on at an acute angle and reassemble. Simply screw the new ring on until it is tight.

10 minutes to install on a 2019 fxbb Harley Day Maker 5.75 lamp. As others have said, I unscrewed the grille from the retaining ring, tilted it and it immediately moved forward. Not very tight fitting to avoid slack to keep the grille in an undesirable position I wrapped 2 turns of tape around the lamp body. Now it fits perfectly, looks aggressive and further dims the lamp. There is no noticeable difference in light blocking.

Installed on a 2001 Sportster XL1200. (I have two), unscrewed the grille so it's in two pieces, put the backing on the front of the light over the rubber piece that stayed there after the ring was removed, screwed on the front of the grille and moved it around like that . it was oriented vertically. Disclaimer: I'm writing this right after installation. I haven't checked while driving. I've read that others have had vibration issues. When this happens I will use a small piece of tape to secure…