🚗 Automotive Hand Held Vacuum Pump Tester Kit with Sponge Protected Case, Adapters, One-Man Brake and Clutch Bleeding System (16pcs) Review

Good for removing old fluid straight from the master cylinder without leaving mess. And when your system lets you suck fluid out of the caliper, the job is a lot easier than pumping and holding.

Poor design, I don't understand why they made the pressure release button as small as needles. Be careful not to press too hard with your finger as this may cause bleeding. Why not cover with some kind of gum etc.?

Again cheap Chinese junk with many sellers selling the same thing. Absolutely no suction - right out of the box. I bought it for the price and recommendation from Revain. Back to Revan. Bought MityVac - works great.

The tubes are too big to solder properly. The pen is broken so you can't pump it up after I used it for 10 minutes. It's almost impossible to make this a closed vacuum system, either by modification or by using parts from my old kit.

Looks like the old Sunpro brand that has been around for years. Hopefully this one lasts just as long. They may have been made by the same Chinese manufacturer as Sunpro. I tested an old vacuum EGR system with this and it worked fine.

I bought this for my bike and it worked great on the rear caliper, then I used it on the front caliper and it broke. I had to finish bleeding the front caliper the old fashioned way. I couldn't return it because the time ran out so I threw it in the trash.

The kit does not come with any instructions as stated in the description. There are also no master cylinder fittings, so it's also not a master cylinder kit as stated in the manual. I was able to get it working with two large brake bleeders. I simply connected the master cylinder to the reservoir with hoses connected to the master cylinder hose fittings. Make sure the other ends of the container are submerged in brake fluid. I then either bled the brakes or pushed the piston by hand over and…