🚗 Chevy/Gmc Pickup Front Leveling Lift Kit - MotoFab Lifts CH-2.5 for 2.5-inch Lift Review

5 stars for the product 1 star for the company. I have a 2016 Silverado and was very nervous about buying a 2.5" alignment kit based on some reviews and research. I opened the kit and it doesn't say which kit I bought so I measured the product and it showed 1 5/8" so I did a little research and found out it was 2.5". I have a basic knowledge of working on cars and trucks and started installing the kit on my own at around 4:45am, took a few smoke breaks and didn't finish it until 7am. Overall I…

Complete restoration of the Silverado front - and added this one. There is nothing wrong with the product, except that a front-end orientation is no longer possible. Snap-On Leveling Machine will not turn green. The struts extend the support so that the lower arm is not parallel to the ground, but tilted downwards. Adding the original steering knuckle back to the truck ensures that the upper arm is at the same downward angle (not parallel to the ground) and actually hits the frame stop that is…

Raised the front of my truck exactly 2.5 inches. This made the front of my truck 3/4" higher than the back of my truck and I knew this would happen based on my stock height measurements so I also installed a block 1" higher in the back to have more truck. position a little higher and level. While these spacers are very easy to install, I only wish they came with longer bolts to reattach the factory wiring harnesses when installed in the frame. Also, it will make your truck driving worse since…

Rugged construction, installation is as easy as removing a luggage rack. I think I'll add 0.75 inch back to bevel the post a bit. The 2.5" front lift lined up my Tahoe perfectly, but it caused the Cali to lean a little (rear sag) under hard acceleration and also with a cluttered cargo area. I still give 5 stars because it was my measurements that led me to order the 2.5" instead of the 2", so it was my fault and not the product or the company. Once installed I was able to fit Pro Comp A/t…

Easy to install, but it's better to have an extra hand to help you. I also think for the price this is one of the best alignment kits out there. Update: After driving a few miles, I noticed that my stock 20x9 wheels were rubbing on the upper control arms. I also have an intermittent pop or clunk coming from the A-pillar position when turning a full turn. I went back and double checked everything to see if I missed anything during the install process. I retightened all the bolts and even…