🔧 Micro Trader 3-Piece Water Pump Pulley Hub Clutch Fan Holding Tool Set with 32mm & 36mm Spanners, Grey Review

I bought this to remove the fan clutch on my Chevy Blazer and it has worked great for that purpose. The wrench holding the pulley in place fitted the pulley on the side with the longer cut hole perfectly, and I was able to use the large wrench to turn the fan clutch with ease. I didn't need the other key for anything, so it was a bit of a waste, but who knows, maybe one day I'll use it for something.

Bought this fan clutch replacement kit for my '93 Ford Explorer. A 36mm wrench fitted, but after spending over 15 minutes fitting the pulley holder (the holes don't match the bolts. You have to unscrew them and use them to attach the pulley holder/rod) I got the wrench on nut attached to the fan clutch, which was held by the rod and tried to unscrew it. I heard a loud metallic "clap". It wasn't a fan clutch nut, it was a wrench. The end of the key was split and bent and could not be used…

I have a 2004 Chevy Colorado with a 3.5 liter i5. I disassembled the water pump, which required a 36mm wrench in the kit. The key itself is acceptable. It fits where it needs to be. The quality of the metal used to make the tools is similar to Pot Metal (very similar if you're familiar with Harbor Freight). The only issue I have is with the tool holding the pulley itself. The holes on the tool were smaller than the bolts that attached the pulley to the water pump. I can only assume that this…