Review on 🔧 Micro Trader 3-Piece Water Pump Pulley Hub Clutch Fan Holding Tool Set with 32mm & 36mm Spanners, Grey by David Roberts

I have a 2004 Chevy Colorado with a 3.5 liter i5. I disassembled the water pump, which required a 36mm wrench in the kit. The key itself is acceptable. It fits where it needs to be. The quality of the metal used to make the tools is similar to Pot Metal (very similar if you're familiar with Harbor Freight). The only issue I have is with the tool holding the pulley itself. The holes on the tool were smaller than the bolts that attached the pulley to the water pump. I can only assume that this kit is primarily for non-domestic vehicles. Because on my particular car, the pulley holding tool was practically useless. I used a drill press to drill the holes to the size I needed to make it work. After that, both tools (per my improvisation) were able to easily work together to loosen the fan clutch nut. The same applies to the new installation.