Raspberry Pi OV5648 5MP USB Camera Module 2592x1944 HD Small Size Auto Focus UVC Protocol Driver-Free Sensor for Raspberry Pi Jetson Nano @XYGStudy Review

The product works well, I bought it to work with Lightburn for my laser. The clarity isn't as good as I was hoping, but it gets the job done as needed.

Oddly if you shake this camera while it's active it loses connection, but when stationary it works fine. I use it as a camera overlay for my laser engraver and it works great.

This camera was purchased for use in a carbon dioxide laser cutter. Almost half the price of some other brands, this little thing works exactly as it should. We made a small case for it on a craft cad and printed it on a 3D printer. After a little calibration it works perfectly.

I bought this to use in my Laser Boss 1420, the viewing angle is not wide enough to see the entire bed only in the 8x11 inch range to see you plan to place it on glass. with the lid closed, as I had hoped, but with the lid behind the handle, the door open, and lots of patience. I was finally able to calibrate it.

I bought this camera module to use with the Lightburn software for my laser cutter/engraver. I 3D printed a camera mount, bought a USB extension cable and attached it with strong double-sided tape. I then used Lightburn's calibration program to align the camera and it works great and saved me money.

I hooked this up to my laser machine for use with Lightburn and it works great. It was smaller than I thought it would be so I attached it to a wire twist popsicle stick and then hot glued the stick to attach to my laser hood. I attached a wire to the hood handle and then to a round drive rod at the front of the laser bed. Works great to restore correct spacing.