🔌 Electrical Controls & Indicators

3 Review

💡 Industrial Electrical, 🔌 Electrical Controls & Indicators

AZ2280-1A-120A ( pack of 2). Miniature Power Relay. A powerful relay in a small package!. Epoxy sealed versions available. Zettler Miniature Power Relay 30A SPST 120VAC AZ2280-1A-120A.

3 Review

💡 Industrial Electrical, 🔌 Electrical Controls & Indicators

【Limit Support Voltage】 2000 V/min. 【Operating Frequency Range 】 20 Hz ~ 400 Hz. 【Length of test leads 】approx. 1 meter long (3.3 feet). 【Protection Level】2000 V (impulse voltage 4000 V). 【Limit Time for Continuous Use】60 minutes maximum at 60V AC 4 minutes maximum at 600V AC.Used to measure the opening phase condition and sequence through LED and Buzzer…

3 Review

💡 Industrial Electrical, 🔌 Electrical Controls & Indicators

Fitting - The speed controller can only be used for 110V DC motors. Soft-start - Temporarily reduce the load and torque in the electric current surge of the motor during start-up. Reduces the mechanical stress on the motor, as well as the electrodynamic stresses, extending the lifespan of the system. Continuously variable speed - Change speed seamlessly…

3 Review

💡 Industrial Electrical, 🔌 Electrical Controls & Indicators

★ Product Name: No lock Push Button Switch; Action Type: Momentary Action, Push and Hold - ON, Release - OFF. ★ Mounting Thread Diameter: 16mm / 0.62", Total Size: 24.4 x 20mm/ 0.96'' x 0.79" (L*D). ★ Voltage: AC 250V/3A AC 125V/6A; Material: Plastic, Electric Parts. ★ Widely is used for circuits control in electromagnetic starter, Contactor, Relay and…

3 Review

💡 Industrial Electrical, 🔌 Electrical Controls & Indicators

.

3 Review

💡 Industrial Electrical, 🔌 Electrical Controls & Indicators

★ Product Name: No lock Push Button Switch; Action Type: Momentary Action, Push and Hold - ON, Release - OFF. ★ Voltage: AC 250V 3A / AC 125V 6A; Mounting Thread Diameter: 15.8mm / 0.62", Total Size : 24.4 x 20mm/ 0.96" x 0.79" (L*D). ★ Material: Plastic, metal; Terminals: 2 Pin, Electric Parts. ★ Widely is used for circuits control in electromagnetic…

3 Review

💡 Industrial Electrical, 🔌 Electrical Controls & Indicators

Use of imported original chip, built-in low on-resistance MOS switch. Dual H-bridge motor driver, can drive two DC motors or a 4-wire two-phase stepper motor. Dual 1.5A * 2, the peak current to be 2.5A, built-in thermal protection circuit, do not be afraid motor stall burned, automatic recovery after the temperature dropped. Minimal heat, no heat sink…

3 Review

💡 Industrial Electrical, 🔌 Electrical Controls & Indicators

Item Name : Rocker Switch;Type : KCD4;Position : ON-OFF; Main Color : Black, Red;Material : Plastic, Metal. Contact Type : DPST;Pin Quantity : 4;Voltage & Current : 16A 250V AC20A 125V AC; Mounting Size : 30 x 21mm/ 1.2" x 0.8"(L*W);Overall Size : 31 x 25 x 35mm/ 1.2" x 1" x 1.4"(L*W*H). Application for it many car, motorcycle, boat, some machine,water…

3 Review

💡 Industrial Electrical, 🔌 Electrical Controls & Indicators

Production Name: Air Conditioner Contactor, Poles: 2P, Rated Current: 40 FLA Amp, Coil Voltage:24V AC, Terminal Size: 1/4 in Standard, Max.Withstand Voltage: 600V AC. This contactor has heavy lug screws terminal and 4 pcs male 1/4 in standard terminals for quick connect, convenient for your fast replacement. Widely used for air conditioner's condensor…

3 Review

💡 Industrial Electrical, 🔌 Electrical Controls & Indicators

【Momentary Switch】Suit automatic gate openers, exit buttons,etc.large outdoor push button. 【One Button】One push button to control, press one for opening.one button exterior opener. 【Waterproof】Protective level of the product is IP54, good for indoor and outdoor use. 【High Quality】Weatherproof Push Button Switch is made of ABS material, exquisite…

3 Review

💡 Industrial Electrical, 🔌 Electrical Controls & Indicators

Genuine OEM Trombetta Part.

3 Review

💡 Industrial Electrical, 🔌 Electrical Controls & Indicators

Cup Turner Motors Power: 4 watts; AC voltage range: 100-127 V; Frequency: 50/ 60 Hz; Rotating speed: 5-6 R per minute; Manner of working: CCW/ CW. Tumbler Motors Size: Motor is 1.9 inch/ 4.8 cm in diameter, 1.57 inch/ 4 cm in height; Cable is 0.08 inch/ 2 mm in diameter, 15.7 inch/ 40 cm in length. Efficient synchronous motor: small power consumption…

3 Review

💡 Industrial Electrical, 🔌 Electrical Controls & Indicators

SPST Button Switch 2 Pins 2 Positions(OFF/ON). AC 125V 3A, AC 250V 1.5A;Poles : SPST;Terminals Quanlity : 2 Terminal. DPDT Toggle Switch 6 Pins 2 Positions(OFF/ON). Model NO. : MTS-202;Rated Voltage & Current : AC 125V, 6A;AC 250V 2.5A. Pin Number : 6 Pins;Position : 2 Positions(ON/ON);Type : DPDT.

3 Review

💡 Industrial Electrical, 🔌 Electrical Controls & Indicators

85A normally open contacts, SPST, One circuit, Off - On. Housing, plated steel. Studs, copper 5/16-Inch -24 thread, hex nuts and lock washers included. Coil, ignition and ground terminals, Steel 10-32 thread, hex nuts and lock washers included. Bracket mounting holes 5/16-Inch x 19/32-Inch (7.9 x 15.1) on 2 13/64-Inch centers (56.0mm).

3 Review

💡 Industrial Electrical, 🔌 Electrical Controls & Indicators

Model Number: LY2-UA-006244. Item Package Length: 3.3858267682". Item Package Width: 2.2047244072". Item Package Height: 1.1023622036".

3 Review

💡 Industrial Electrical, 🔌 Electrical Controls & Indicators

Dry reed tube compact structure, small weight, can be installed in the extremely limited space, very suitable for miniaturization equipment. Dry reed switch components are hermetically sealed in an inert gas atmosphere, never contact with the external environment, long working life. Dry reed tube does not use sliding components, so there will be no…

3 Review

💡 Industrial Electrical, 🔌 Electrical Controls & Indicators

Brand: LSE Lighting - EPA Est. No. 96823-PA-1. Wattage: 43W. Length Approx: 15 1/2" (391mm). This combo kit by (LSE Lighting brand) is 100% compatible replacement for use with UVMax C D C4 D4 D Plus, D4 Plus. All products listed are compatible brand (LSE Lighting) UV products. We do not sell Trojan brand products. All Trojan brand names, trademarks and…

3 Review

💡 Industrial Electrical, 🔌 Electrical Controls & Indicators

✔Type: X/Y/Z Axis End Stop Limit Switch. ✔Compatible with all Creality 3D Printer. Optical Endstop limit switch for Ender-3/CR-10/CR-10S/CR-S4/CR-S5/CR-10S Pro, Ender-3/Ender-3 Pro 3D printer. ✔Maximum voltage: 125V, Maximum current: 1A. Size: 1.0x0.8 x 0.3in/2.6x2 x 0.7cm. ✔Easy to install: 3 Pin N/O N/C control, easy to use micro switch, DIY must…

3 Review

💡 Industrial Electrical, 🔌 Electrical Controls & Indicators

✔Type: X/Y/Z Axis End Stop Limit Switch. ✔Compatible with all Creality 3D Printer. Optical Endstop limit switch for Ender-3/CR-10/CR-10S/CR-S4/CR-S5/CR-10S Pro, Ender-3/Ender-3 Pro 3D printer. ✔Maximum voltage: 125V,Maximum current: 1A. Size: 1.0x0.8 x 0.3in/2.6x2 x 0.7cm. ✔Easy to install: 3 Pin N/O N/C control, easy to use micro switch, DIY must limit…

3 Review

💡 Industrial Electrical, 🔌 Electrical Controls & Indicators

Buttons are 6mm tall. Base measuring 6 x 6mm. Rated for 50 mA of current. Packet of 10 buttons.