🔧 Accusize Tools 0021 Straight Industrial 0828 Review

I used it with a straight edge clamp and a DeWalt router to level the edge on a 6 inch thick table. There were no problems getting a smooth and even edge. The top surfaces were made of MDF (1 1/2 inch thick). ), resting on pine boards, the chisel is still sharp, no damage.

I bought this to make some really deep grooves on a gate I was building. The quality and sharpness of this beat is very good. It wobbled a little when it was very deep (3.5 inches), but that's to be expected and doesn't hurt the cut at all. No worse than beats twice the price. I would buy again.

This product is garbage. Used for the first and only time today. On the first cut attempting to cut into soft jaws, the shank warped and knocked a nick out of the "carbide" cutter. It's too late to get a refund so I'm just warning everyone not to waste their money. I'm just glad it didn't bend the shaft on my router.