Carry-On Trailer 817-2 Marker Light: A Reliable Trailer Accessory Review

too stingy with wire leads from light. makes it difficult to connect to the trailer wiring harness. Good value for a simple, essential item that can easily damage your trailer.

from carry on luggage tags! just what i needed. The perfect original piece for an imperfect stone prolapse! arrived in good condition, not connected yet but it's easy.

I bought this because the lenses on my trailer headlights were cracked and broken. I had to buy the whole world in the collection. As far as I know the lenses are not sold individually. But yes, they fit perfectly and look just like the real thing.

Bought to replace the broken carry on tag. Ironically, TSC (the store that sold the trailer) didn't sell them. This one was the perfect replacement. The only downside is that it is expensive compared to other parking lights on the market. Actually about twice as expensive. So minus only for the value.

This is an exact replacement for the lights that came with my carry on tag. Advantages? It's easy to install and uses a standard 194 wedge bulb, making the transition to LED very easy. minuses? It's much more expensive than other marking options and not very water resistant (you can use dielectric piston grease to prevent long-term corrosion).

Bought a new trailer and had to drive many miles to get home. Upon arrival I noticed that the case (not the yellow lens) was broken. I found this replacement that looks exactly like the original. It was difficult to install, not necessarily because of the swap, but because the wiring at the trailer is too tight - there's absolutely no excess play. I could barely get to the clip holding the wires. Due to the lack of an extra cable on the trailer, the replacement cable was not long enough. I cut…

then this is what you need. It is manufactured by Carry-On and is a direct replacement. I give it four stars because it says exactly that. I took off a star because at this price a light body should last forever, but it doesn't. They rust inside after a few years. I thought since there is nothing more to say about this light I would like to talk a little bit about the replacement process. Let's start with the built-in splice connector, shown in blue in the picture. If you have a few inches of…