Nylon Mesh Fish Fry Hatchery Breeder Box 🐟 Separation Net by XMHF: Efficient Separation for Successful Fish Breeding Review

I WAS REALLY EXCITED TO RECEIVE THIS. ARRIVED IN RECORD TIME. ASSEMBLY WAS EASY ENOUGH BUT THE NET HAS TO BE STRETCHED ON PLASTIC RODS WHERE THE VACUUMS WERE INSTALLED. THIS GETS A TENSION ON THE NET THAT IT WILL END UP. NOT LIKE THE TATS TO HOLD MORE THAN ONE DAY, EVERY DAY UNTIL I FINALLY RELEASE THE BABY FISH FOR FREE AFTER THREE DAYS OF PREPARATION. Luckily they are still surviving and growing, to my surprise they were not eaten. VERY DISAPPOINTED. YOU MUST CHECK THIS DESIGN.

The instructions on the box were poorly written. I had imagined the suction cups to be a little larger. I have to be careful not to bump into the product as it slides off a bit. Assembly was easy once I figured out what goes where. I couldn't figure out how to attach the extra suction cups to the bottom of the product the way I need them so I just use two like the picture on the box. On the other hand, it was much easier to put together and use right out of the box than the tank divider I…

This thing is cheap, and I mean cheap. It's basically a hair net and a very cheap plastic frame. It came with no instructions, and while it was obvious how to assemble it, the trellis ended up not being big enough for the box. If you look at the top picture you can see that it has a lot of stitch overhangs over the edges, if you look at the last picture it's closer to how it really fits, but mine doesn't even go all the way over the edges. Suction cups are as small and thin as they make them…