🔩 Tahlegy Extension Hardware Bearing: Premium Industrial Hardware for Drawer Slides Review

built new work tables for my shop and used slides for 32 drawers and 8 drawers. They worked great but each pair only comes with six (6) screws which is not enough to hold the cabinet and drawers in place. I used 5 #6 x 1/2" wood screws for the side of the cabinet and the six (6) screws that came with the drawer slides.

Based on 0 ratings to complete the project on time. They arrived at noon and I immediately opened them and examined them. The fit and finish were as good or better than the LSI slides I usually get. The ball bearing guides worked well and were smooth. The initial opening and subsequent closing/latching were tighter than I'd like, but they should loosen over time or you could shave/file the stop. Of the 10 pairs of rails, 7 fasteners and only 6 cheap, easy-to-remove screws are included. I…

Overall a good set of slides. I used them in my workshop. I loaded a 57 lb drawer and the slides handled it pretty well except they buckled when they were more than half open. I didn't test for more weight because I put a maximum of 30 pounds in it. I like the rubber lock to keep the drawer from sliding out but after all my closet is pretty shallow and so far these drawers have been pretty tight to pull out so I'm not sure if it's necessary but it's easy to accept. rubber part. I would use them