Review on LASTBUS License Plate Wireless Backup Camera – 170° View Angle, WiFi Rear View Camera, IP69 Waterproof Car License Plate Frame Camera for Car Truck SUV Pickup Trailer Van Camper by Brian Olson

first note that if you can't hide the black wire through the connector next to the license plate lights or near the license plate area, you will need to drill a hole in the middle of your truck. Lay the cable to the LIGHT CABLE. If you stretch the cable to the reversing light, the connection to the phone via WiFi is too slow. Don't expect the camera to turn on immediately. The camera needs to connect to your WiFi network before the image is displayed. It may be too slow when you put it in reverse. The picture is pretty good. I get 25 to 30 frames per second. Easy installation without a specialist. The camera aligns perfectly. You can record while driving, which comes in handy when I sense someone following me too closely. There were problems with the 1st apps when they arrived and with my IOS update. The seller responds quickly and solves the problem in a few days. The Wi-Fi connection is slow, which seems to be standard with all wireless cameras. So don't expect it to be quick no matter what brand you buy. Will I buy another one from this seller? After everything I've been through, YES! *Recommendation - 1 - Buy a hollow short rubber tube to fix it around the wire and a hole to make it waterproof. 2 - Use T-Tap to connect my wires together (black to black and color to color). With T-Tap you cannot cut or strip the wire to a minimum. 3. I also connected a short (6 inch) speaker wire to the antenna to extend the connection (this should help people using a trailer). 4 - To prevent my camera from being stolen, I buy a standard star/hex license plate screw from my local auto parts store or here at Revain. 5. Make sure you allow the camera to access your camera on your phone, otherwise the app will not work. 6 - I turn on the light as I approach my destination, so my wifi on my phone and camera takes time to connect. Then I just open my application.