Review on 3D Printer Creality Ender 3 Pro Black by Dagmara Ziomek ᠌

8-bit board (slow, even the menu slows down.); no support for BLTouch from the manufacturer (there is no way to attach it on the board, unless you dance with a tambourine); and noisy (the drivers make the motors generate noise since the motors are controlled by the driver), and the drivers are soldered into the board (they cannot be replaced); curved table (precision is needed high 0.1 mm at least, so that the first layer lays down); a simple extruder (specifically, feed gears + plastic, which is elastic, which is terrible); curved table Bowden tube with a significant amount of backlash on the inside, located directly under the filament (why is this done? I have no idea); the coolend fan blows on the model, which is a terrible thing, and because it is not of great quality, after 10 prints it will be very loud; fan blowing model 4010, which is insufficient for some of the duties at hand; Z-axis curve - you must print the gasket as soon as possible; the airflow of the board is paralleled with the airflow of the model (that is to say, if the airflow of the model is set to 0 when printing, the board will not be cooled.); all of the wires are not beaded but are instead strewn about in an unorganized manner.