Review on 🚀 Unleash Your Vehicle's Power with the Superwinch 1145220 Terra 45 Winch by Patrick Reynolds

Buy the correct winch mount and dash switch first. Instructions are not unit specific, but must be followed. #one. Remove the bumper, install the winch bracket, winch and fairlead, hand launch rope/cable as instructed before reinstalling the bumper. #2. Remove the upper instrument panel, there are 3 marks for the wired remote control in the middle of the lower part of the panel, drill according to the instructions and install the connector. If you purchased a dash switch, remove the center dash and install the switch. Cut the wires from the handlebar switch and use them for the dash switch. Run the wires through the firewall and connect the two red wires to the power pole under the hood next to the "Winch Contactor" sign. #3. Remove the passenger seat and storage tray. Disconnect the battery, remove floor cover center bottom No. 4. Route the wiring down from the dashboard and through the hood opening to the battery. Connect the 6 gauge blue and yellow wires to the winch and route them back to the battery. Connect the black 6 gauge wire to the ground terminal on the frame under the storage box and the longer red 6 gauge wire to the starter relay battery #5. Drill a 3/4" or larger hole in the bottom of the central electrical box and feed all the wiring through. #6. Install the winch contactor and circuit breaker in the electrical box and connect the wiring as shown. Tie the Cables together, connect battery, check winch and coil rope/cable.