Review on Enhance Your Additive Manufacturing with Top-Quality PLA Filament Products by Steven Loy

Update: Due to problems sticking to the table I recalibrated my Ender 3 v2 and printed at a lower speed. My settings were 220s/60s/60mm cruising speed. It seems to be working, but I won't know for sure until I get home. Overall it took a bit more effort to get this thread going than something like ESUN, but it's looking pretty good. I will contact you as soon as I get home to assess further evaluation. Initial Rating: Title. I'm a little upset. I wanted to try this marble thread since it was on sale. There are no problems feeding it into the extruder. The problem is that the filament is not printing properly. I've tried finding the size of the time, the size of the cat, searching on reddit etc and I still can't print this particular thread in a meaningful way. It's all spaghetti on the printable table. I am very unhappy with it and really hoped the material would print better. I'm going to dry it in the Jayo dryer overnight and try to print again tomorrow, but I'm not holding my breath. At the moment the brand I have been very lucky with is called ESUN PLA Pro. Both roles worked perfectly. I'll be fiddling with marble thread as I really don't want to waste a 1kg roll, but it will likely be used for less important prints in the future. If I can print it at all.