Review on MakerFocus 2Pcs OLED Display Module I2C 128X64 1 by Phillip Jaylon

Name: MakerFocus 2Pcs OLED Display Module I2C 128X64 1
Item: MakerFocus 2Pcs OLED Display Module I2C 128X64 1
Rating: 5

October 05, 2022

Pay attention to the Vcc/Gnd pin placement

I ordered these OLEDs for use on a TTGO T board but didn't notice the Vcc/Gnd pins conversely of what you are needing on the teeing board. my fault I had to cut the power/ground connections to swap them out. In general, OLED boards are very good. If the contacts are in the right place or it doesn't matter to your project, this is a great prize.

Pros

Great for a small house

Cons

Legacy model

New products

Comments (0)

Please, sign in to write a comment

Top products in 🖥️. Single Board Computers

GeeekPi Raspberry Pi Cluster Case with Cooling Fan and Heatsink for Pi 4 Model B, 3 Model B+ & 3/2 Model B

4.27

11 Review

🌐 MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi

2.81

11 Review

REXQualis Comprehensive Starter Kit with Arduino MEGA 2560 & Detailed Tutorial for Arduino IDE Compatibility

4.91

11 Review

🎁 Ultimate BBC Micro bit Sensor Starter Kit: Keyestudio 37-in-1 Box with Tutorial, Compatible with V1.5 & V2, Gift for Kids and Adults (Microbit Board Not Included)

4.47

11 Review