I just took mine out of the box. Here's what I think: I've read reviews that talked about air leaks. While the included air hose is flimsy and doesn't look like it will last very long, mine worked right out of the box. I made sure the clamps were good and tight and wrapped a lot of teflon tape around the regulator's threads. I'll definitely be replacing the hose soon. I agree that the regulator is not the best. I will most likely replace it. But mine isn't leaking and seems accurate. It's measured in MPa, not psi, which isn't very useful. I'm sure my first purchase will be a new sensor. Along with the machine I bought a number of additional consumables (although some come with the machine). This separate purchase included a set of small snap-in rails. Not the best, but better than handmade, which is what you need without a separate purchase. I cut through a piece of 18ga steel. It made a clean cut in about three seconds next to a cut of the same size that took me several minutes with a grinder. amplifier setting. Quite a lot of slag, but that didn't bother me. I've wanted a plasma cutter for a long time but didn't want to spend $1,000 on the one I had my eye on. Finally, I pulled the trigger a few times. a few days ago when I was sharpening a locked piece of 18ga steel. The wheel of my mill is stuck. The sharpener slipped out of my hand and landed on my leg. She cut through thick linen pants and slapped my thigh. No stitches but I will always have a scar there. Bottom line, it's worth the money, and if you haven't used one of these before, you'll love it.
π₯ Whizzotech Solder Wire 60/40 Tin/Lead with Flux Rosin Core - 0.032 Inch Diameter for Electrical Soldering (4oz/100g/0.22lb)
13 Review
Hakko T18-BR02 Soldering Tip - T18 Series for Hakko FX-888/FX-8801 - Conical Shape - Bent 30 Degrees - R0.2 mm x 10.5 mm
12 Review
309LFC-O X .035 X 1LB Spool Gasless Stainless Steel Flux Core Welding Wire by Blue Demon
12 Review
Hakko 599B 02 Wire Type Soldering Cleaner
11 Review